Then, when I tried a reboot, I got a request to perform a system repair because of the bad startup.I tried the repair and got the above error message indicating the error code 0x490.
System Files Integrity Check 0X490 Update Was InstalledI tried a system restore, because a critical update was installed on my system, by the system last night, but I dont know if that was the cause.I googled for a solution, and some people had to reinstall their operating system.
One guy just had to identify a hardware conflict, and disable ACPI in Bios. System Files Integrity Check 0X490 Windows 7 Pro DellWhat would disabling ACPI do Windows 7 Pro Dell XPS710 Studio. Corruption and repairs just arent needed like they are in Windows. During this latest increase, Windows 7 will launch the automatic repair, which when the user attempts to allow it to repair, ends up failing and results in a boot loop where the repair mode comes up and Windows cannot boot into the regular shell any longer. ![]() I do have to admit the repair tools are very easy to follow, all completely wizard-driven, however seldom have I seen them actually work or fix the problem at hand. However even with that, the PC reboots itself just before the Windows shell would come up. This is much faster than re-installing Windows manually or trying to diagnose the list of error codes provided by Microsofts tools. System Files Integrity Check 0X490 Archive And RestoreIf Microsofts own repair tools could simply fix the issue, it would be a huge time-saver as the system could be fixed within minutes, rather than hours that it takes to re-image a system and archive and restore user data. The problem is, Ive rarely seen the Microsoft repair tools actually fix anything. Since the issue at hand is a boot issue, I selected Startup Repair. It shows the primary disk in the system and the partition, along with the tests performed which include: disk, OS, registry, and other volume information. Then at the bottom it says Root cause found: Unspecified changes to system configuration might have caused the problem. Result: Failed. Error code 0x490. Time taken 784575 ms. So, why cant the repair tools, actually repair something Cant system files be copied from the source DVD and restored, without doing a full re-installation Apparently not. A prompt came up, Once started, the system restore cannot be interrupted. Immediately the main menu comes back up and a message pops up saying Restoring files. After a couple of minutes of churning, the error comes up System Restore did not complete successfully. ![]() Click Close and the system reboots itself. A minor annoyance, I just have to boot back into the recovery tools. Two other restore points were tried and the same error resulted. No cause has been found for this latest round of corruption and boot problems. This time as I mentioned above, is better spent re-imaging a new system. For those who say that Windows 7 has superior stability or is miles above XP, are only kidding themselves. Even after a year of deploying Windows 7 over XP, there is still little return on investment seen. In fact, I think there is still a deficit because of the resources used not only for troubleshooting ongoing Windows 7 problems, but for testing and re-purchasing incompatible applications. Since the Linux boot sequence is far less complex than Windows, the kernel can at least boot and get the user to a command prompt (in case X11 cant start), allowing for further troubleshooting of log files. Fortunately, I havent needed to run a repair like this for GNULinux in a long long time.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |